BitEdit China Bosch MG1

Product Description:

Software Activation From BitSoftware with Product Number: MK22972

Specs:

Manufacturer: BitSoftware

Module China Bosch MG1

Software module for editing calibrations Bosch MG1UA008 and MG1US008 ECUs of petrol vehicles from Chinese market (JAC& Wey& Haval& Saic& Great Wall& Tank& Chery& Changan& SWM& GAC& FAW& Beijing& MG& Dongfeng etc...).

Module supports files 2.5Mb and 4Mb size.

Supported maps:

Air calculation: Air mass through throttle body& Calculation of nominal charge& Limit for maximum desired air charge& Maximum air charge for protection against over boost
Boost control: Boost pressure target in the calibration mode& Characteristic pressure ratio over turbine of high dynamics& Compression ratio for protection over speed of supercharger& Compressor efficiency& Compressor ratio for over speed turbine protection& Desired position boost pressure actuator& Westgate characteristic field of standard dimensions& Correction factor compressor efficiency
Engine speed limitation : Engine speed limitation during high temperature& Engine speed limitation from gear& Maximal engine speed at high oil temperature& Engine speed limitation in case of vehicle speed detection error& Maximal engine speed& Maximal engine speed in manual mode& Maximal engine speed in sport mode& Stationary engine speed limit& Stationary engine speed limit at high engine temperature& Stationary engine speed limit in manual mode& Stationary engine speed limit in sport mode
Fan Control (Test)
Function monitoring: Map of optimum engine torque in function monitoring& Optimum ignition angle& Ignition efficiency depending on delta ignition angle in monitoring& Lambda dependency of optimum ignition angle in function monitoring& Lambda efficiency in function monitoring& Maximal inner torque in monitoring& Overrun air charge factor in monitoring
Idle speed: Desired idle speed
Knock control: Knock detection factor characteristic map cylinder counter
Lambda: Delta nominal Lambda for component protection& Lambda component protection& Lambda component protection in case of detected camshaft error& Lambda correction for exhaust temperature at valve bank& Lambda engine during after start& Lambda engine nominal at warming up with active A/F control& Lambda engine nominal at warming up with active A/F control during dynamic conditions& Lambda enrichment for component protection& Target lambda for preventing pre-ignition& Minimum lambda value for component protection& Nominal Lambda for component protection& Lambda efficiency
Limiters: Vehicle speed limitation depending on gear& Maximum vehicle speed for Cruise Control& Minimum vehicle speed for Cruise Control
Requested torque: Accelerator pedal in sport mode& Driver command torque limitation& Engine drag torque& Inverse pedal position& Load torque for low idle& Load torque for reverse gear& Maximum indicated torque for overpower protection& Maximum indicated torque limitation factor for overpower protection& Optimum engine torque& Requested torque in additional mode& Maximum indicated torque for overpower protection& Parameter maximum torque& Parameter minimum torque
Spark advance: Spark advance in additional mode& Spark advance angle characteristic& Delta ignition angle from efficiency
Temperature correction: Compensation for intake air temperature for determination of environmental air temperature& Exhaust gas temperature calculated& Exhaust temperature valve homogeneous mode& Exhaust temperature correction based on intake air temperature& Exhaust temperature valve with offset correction based on air temperature in manifold& Exhaust temperature valve with offset correction based on environment temperature& Temperature factor for air at throttle valve
Throttle valve control: Desired throttle angle& Throttle angle at maximum mass flow& Full load recognition threshold& Throttle angle dependent on accelerator pedal position
VVT: Exhaust camshaft position& Intake camshaft position
DTC

Supported SW list for Module China Bosch MG1